GBA long cart cases?

[kuriatsu 65]

I mentioned in my previous thread, that I had some GBA long cart prototypes.

Can anyone recommend any good cases for those?

So far, I've been using some anti-static bubble wrap on the cart, inside of an anti-static bag, inside of another sheet of anti-static bubble wrap, inside another anti-static bag, with 1-2 other carts in the same protection, wrapped in another layer of anti-static bubble wrap on the inside of a thick pokemon deck box that's a little longer than the carts are by about an inch or 2.

Needless to say, this is overkill. Does anyone have any suggestions of a decent case I can use to trim down the "waste"?

This is actually one of the pictures I took of one of my carts as an example:

 

Edited February 8, 2020 by kuriatsu
adding image

[SNESNESCUBE64 401]

What are the rough dimensions of the cartridge?

[Nes Freak 574]

you can problably get a custom anti static case made to protect it.

[kuriatsu 65]

On 2/9/2020 at 3:21 PM, SNESNESCUBE64 said:

What are the rough dimensions of the cartridge?

its width at widest is about maybe an 8th of an inch. (maybe a 5th of an inch)

Its height is about 4.5 inches, maybe 5 inches.

Its length is the same as a gameboy cart, so about 1.5 inches.

  

On 2/9/2020 at 4:09 PM, Nes Freak said:

you can problably get a custom anti static case made to protect it.

Thats what I'm thinking of doing but all the ones I've seen have been too expensive for me to get 6 of.

Edited February 11, 2020 by kuriatsu